E 450 V8-5.4L (2009)
-------------------------------------------------
D6 CHECK THE TBC MODULE PWM OUTPUT CIRCUIT FOR AN OPEN
-
Measure the resistance between trailer tow 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and TBC module C2142-14, circuit
CAT19 (BU), harness side.
-
Is the resistance less than 5 ohms?
Yes
GO to D7.
No
REPAIR circuit CAT19 (BU). CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
D7 CHECK THE TBC MODULE FOR MAXIMUM OUTPUT
NOTE: Battery voltage must be greater than 10 volts.
-
Ignition OFF.
-
Connect: TBC Module C2142.
-
Ignition ON.
-
Input a gain setting of 10 into the TBC module.
-
NOTE: If the manual slider switch is held to the full left position for more than 5 minutes, the TBC module will automatically shut down.
-
Have an assistant press the manual slider switch fully to the left with a gain of 10 on the TBC module.
-
Measure the voltage between trailer tow 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and ground.
-
Is the voltage greater than 10-12 volts?
Yes
The TBC module is operating correctly. SEND the trailer to an authorized camper/trailer repair center for an overload condition.
No
GO to D8.
-------------------------------------------------
D8 CHECK FOR CORRECT TBC MODULE OPERATION
-
Disconnect: TBC Module C2142.
-
Check the connector for:
-
corrosion.
-
pushed-out pins.
-
spread terminals.