E 450 V8-5.4L (2009)
-------------------------------------------------
Y1 CHECK THE TRAILER ELECTRIC BRAKE CONTROLLER FOR A SHORTED OUTPUT
-
Ignition ON.
-
Measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU), component side and ground.
-
Is any voltage present?
Yes
GO to Y2.
No
GO to Y3.
-------------------------------------------------
Y2 CHECK CIRCUIT CAT19 (BU) FOR A SHORT TO VOLTAGE
-
Disconnect: Trailer Electric Brake Controller C2142.
-
Measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU), component side and ground.
-
Is any voltage present?
Yes
REPAIR circuit CAT19 (BU) for a short to voltage. TEST the system for normal operation.
No
INSTALL a new trailer electric brake controller. TEST the system for normal operation.
-------------------------------------------------
Y3 CHECK THE TRAILER ELECTRIC BRAKE CONTROLLER OUTPUT
-
Set the gain on the trailer electric brake controller to the maximum setting.
-
While applying the brake pedal, measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU),
component side and ground.
-
Is the voltage greater than 10 volts?