E 450 V8-5.4L (2009)
Removal and Installation
1. Remove the front door trim panel.
2. Remove the screw and slide the interior door handle forward to disengage the tabs from the door.
3. Position the water shield aside.
4. Release the cable conduit from the interior door handle, then slide the cable end from the door handle pivot.
5. If equipped, remove the door lock actuator rivet.
6. Disconnect the door lock cylinder actuating rod.
7. Disconnect the exterior door handle actuating rod.
8. Remove the front door latch screws.
-
To install, tighten to 12 Nm (106 lb-in).
9. Disconnect the door lock actuator electrical connector.
10. Remove the front door latch assembly.
11. To install, reverse the removal procedure.
-
Using the Heavy Duty Riveter, install new rivets.