E 450 V8-5.4L (2009)
7. If equipped, disconnect the seat control switch electrical connector from under the front of the cushion frame.
-
Note wire harness routing for correct installation.
8. Remove the 3 screws and outboard side shield.
9. Separate all wire harness pin-type retainers attached to the cushion frame.
10. Remove the 4 cushion frame bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
11. To install, reverse the removal procedure.
Seat Cushion - Rear, Bucket
Seat Cushion - Rear, Bucket
Removal and Installation
NOTE: For parts identification and locations, refer to Seat - Exploded View, Rear, Bucket See: Service and Repair/Rear Seats/Seat - Exploded View,
Rear, Bucket.
1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.
2. Remove the seat.
-
Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.
3. For RH seat, remove the bolt and detachable safety belt anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Remove the locator spacer.
-
Note spacer position for correct installation.