E 450 V8-5.4L (2009)
Seat Cushion: Overhaul
Seat Cushion - Front
Seat Cushion - Front
Disassembly and Assembly
1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front See: Seat Back/Service and Repair/Removal and
Replacement/Front Seats/Seat Backrest - Front.
2. Remove the seat cushion cover. For additional information, refer to Seat Cushion Cover - Front See: Seat Cover/Service and Repair/Front
Seats/Seat Cushion Cover - Front.
3. Remove the seat track. For additional information, refer to Seat Track - Front See: Seat Track/Service and Repair/Seat Track - Front.
4. To assemble, reverse the disassembly procedure.
Seat Cushion - Rear, Bucket
Seat Cushion - Rear, Bucket
Disassembly and Assembly
NOTE: For parts identification and locations, refer to Seat - Exploded View, Rear, Bucket See: Service and Repair/Rear Seats/Seat - Exploded View,
Rear, Bucket.
1. Remove the backrest. For additional information, refer to Seat Backrest - Rear, Bucket See: Seat Back/Service and Repair/Removal and
Replacement/Rear Seats/Seat Backrest - Rear, Bucket.
2. For RH seat, remove the seat track. For additional information, refer to Seat Track - Rear, Bucket See: Seat Track/Service and Repair/Seat Track
- Rear, Bucket.
3. For LH seat, remove the 4 nuts and seat pedestal.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the cushion cover. For additional information, refer to Seat Cushion Cover - Rear, Bucket See: Seat Cover/Service and Repair/Rear
Seats/Seat Cushion Cover - Rear, Bucket.
5. Remove the cushion foam pad.
6. Remove the bolt and safety belt buckle.
-
Note safety belt buckle position for correct installation.
-
To install, tighten to 40 Nm (30 lb-ft).
7. For LH seat, remove the 2 bolts and recliner.
-
To install, tighten to 48 Nm (35 lb-ft).
8. To assemble, reverse the disassembly procedure.
Seat Cushion - Rear, Bench, 3-Passenger
Seat Cushion - Rear, Bench, 3-Passenger
Disassembly and Assembly
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to
verify correct function:
-
Retractors
-
Buckles
-
Belt tension sensor (BTS) (if equipped)
-
Front safety belt buckle support assemblies (slide bar) (if equipped)
-
Safety belt shoulder belt height adjusters (if equipped)