E 450 V8-5.4L (2009)
4. Remove the brake pads from the anchor plate.
5. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
-
To install, tighten to 265 Nm (195 lb-ft).
6. To install, reverse the removal procedure.
Brake Caliper
Brake Caliper
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the wheel and tire.
2. NOTE: Use new copper washers on the brake caliper flow bolt.
Remove the brake caliper flow bolt and position the brake hose aside.
-
Discard the copper washers.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the 2 brake caliper anchor plate bolts, the brake caliper and anchor plate as an assembly.
-
To install, tighten bolts to 225 Nm (166 lb-ft) using a butterfly torque adapter (such as Snap-On(R) Stock # SBS26).
4. Remove the 2 brake caliper guide pin bolts and the brake caliper.
-
To install, tighten to 61 Nm (45 lb-ft).
5. To install, reverse the removal procedure.
-
Bleed the brake caliper.
Disc Brake System - Exploded View
Disc Brake System - Exploded View
Rear Disc Brakes (View 1 of 3)
NOTE: RH side shown, LH side similar.
