E 450 V8-5.4L (2009)
REFER to Information Bus to diagnose the HS-CAN bus.
No
REFER to Brake Lamp to diagnose the stoplamp (BPP) switch. See: Lighting and Horns/Brake Lamp/Testing and Inspection
-------------------------------------------------
D4 CHECK THE VOLTAGE TO THE TBC MODULE
-
Ignition OFF.
-
Disconnect: TBC Module C2142.
-
Ignition ON.
-
Measure the voltage between ground and:
-
TBC module C2142-8, circuit SBB18 (YE/RD), harness side.
-
TBC module C2142-12, circuit CBP33 (WH/BN), harness side.
-
Are the voltages greater than 10 volts?
Yes
GO to D5.
No
VERIFY BJB fuse 18 (30A) is OK. If OK, REPAIR circuit SBB18 (YE/RD).
VERIFY SJB fuse 33 (10A) is OK. If OK, REPAIR circuit CBP33 (WH/BN).
If either fuse is not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short.
CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
D5 CHECK THE TBC MODULE GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Measure the resistance between TBC module C2142-11, circuit GD116 (BK/VT), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to D6.
No
REPAIR circuit GD116 (BK/VT). CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------