E 450 V8-5.4L (2009)
Cruise Control Switch: Service and Repair
Speed Control Deactivator Switch
Speed Control Deactivator Switch
Removal
1. NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately
wash it with water.
NOTICE: Make sure the master cylinder reservoir cap is secure before performing this procedure.
NOTICE: Do not allow any foreign matter to enter the master cylinder port once the deactivator switch is removed.
Remove the deactivator switch.
-
Disconnect the electrical connector.
Installation
1. NOTICE: Do not allow brake fluid to contact the electrical connector.
Install the deactivator switch.
-
Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
-
Tighten to 18 Nm (159 lb-in).
-
Connect the electrical connector.
