E 450 V8-5.4L (2009)
Radiator: Service and Repair
Radiator - 4.6L, 5.4L and 6.8L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the cooling fan. For additional information, refer to Cooling Fan - 4.6L, 5.4L and 6.8L See: Radiator Cooling Fan/Fan Blade/Service and
Repair.
3. If equipped, remove the underbody splash shield.
4. NOTE: Typical shown, others similar.
Disconnect the transmission oil cooler hoses.
-
Plug or cap the lines as needed.
5. Disconnect the lower radiator hose.
6. Remove the 4 bolts and the 2 radiator support brackets.
-
To install, tighten to 20 Nm (177 lb-in).
7. Remove the radiator from the vehicle.
8. To install, reverse the removal procedure.
-
If necessary, install new appropriately sized worm drive-type clamps.