E 450 V8-5.4L (2009)
Housing Assembly HVAC: Service and Repair
Evaporator Core Housing
Evaporator Core Housing
Removal and Installation
1. Remove the heater core housing. For additional information, refer to Heater Core Housing See: Heater Core Housing.
2. Remove the evaporator core. For additional information, refer to Evaporator Core See: Evaporator Core/Service and Repair/Evaporator Core.
3. Detach the wire harness.
1. Remove the nut and stud.
2. Disconnect the electrical connector and position the wire harness aside.
4. Remove the 2 suction accumulator bolts and the suction accumulator.
-
To install, tighten to 14 Nm (124 lb-in).
5. Remove the washer reservoir.
1. Remove the nut.
2. Remove the bolt.
3. Remove the washer reservoir.
-
Disconnect the washer pump hose and electrical connector.
6. Disconnect the blower motor electrical connector.