E 450 V8-5.4L (2009)
Removal
1. Remove the wheel and tire.
2. Using the C-Frame and Screw Installer/Remover, remove and discard the wheel stud.
Installation
1. Position the new wheel stud, aligning the serrations in the wheel adapter flange made by the original wheel stud.
2. NOTE: Make sure to use washers that have an inside diameter that is larger than the outside diameter of the wheel stud serrations. Use enough
washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.
Place approximately 4 washers over the outside end of the wheel stud and thread a standard wheel nut onto the wheel stud with the flat side against
the washers.
3. Tighten the wheel nut until the wheel stud head seats against the back side of the wheel extension flange.
4. Remove the wheel nut and washers.
5. Install the wheel and tire.
