E 450 V8-5.4L (2009)
Engine Control Module: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P0130/P0150 Set
TSB 11-3-20
03/15/11
4.6/5.4 - MALFUNCTION INDICATOR LAMP (MIL) ON
DIAGNOSTIC TROUBLE CODES (DTC) P0130 AND OR
P0150
FORD:
2009-2010 E-150, E-250, E-350, E-450
ISSUE
Some 2009-2010 E-Series vehicles equipped with 4.6L or 5.4L engine may exhibit illuminated MIL with DTC P0130 (Oxygen Sensor Circuit Bank 1,
Sensor 1) and/or P0150 (Oxygen Sensor Circuit Bank 2 Sensor 1).
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
1. Check for DTC's P0130 or P0150 in the Powertrain Control Module (PCM).
2. Perform Powertrain Controls/Emissions Diagnosis (PC/ED) pinpoint test DZ to confirm universal heated oxygen sensor (H025) functionality.
a. If H025 sensor is operating correctly do not replace sensor. Proceed to Step 3.
b. If H025 sensor failure is confirmed, replace only the affected sensor as indicated by the DTC observed (Bank1/Bank2). Refer to Workshop
Manual, Section 303-14. Proceed to Step 3.
3. Reprogram the PCM to the latest calibration using IDS release 71.05 and higher or 72.01 and higher. This new calibration is not included in the
VCM 2011.3 DVD. Calibration files may also be obtained at the website.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
110320A
2009-2010 Econoline 4.6L
0.3 Hr.
And 5.4L Engine: Check
DTCs And Reprogram The
PCM
110320B
2009-2010 Econoline 4.6L
0.7 Hr.
And 5.4L Engine: Check
DTCs Replace One (1)
Heated Oxygen Sensor,
And Reprogram The PCM
110320C
2009-2010 Econoline 4.6L
0.9 Hr.
And 5.4L Engine: Check
DTCs Replace Both (2)
Heated Oxygen Sensors,
And Reprogram The PCM
MT110320
For Additional Diagnosis
Actual
Or Repair Related To
Time
