E 450 V8-5.4L (2009)
Air Bag(s) Arming and Disarming: Service and Repair
Reactivation Procedure
Supplemental Restraint System (SRS) Deactivation and Reactivation
Reactivation Procedure
1. Remove RCM fuse 32 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Connect the passenger air bag module electrical connector.
4. Install the glove compartment.
5. Install the driver air bag module.
1. Connect the horn electrical connector.
2. Connect the driver air bag module electrical connector.
3. Position the driver air bag module into the steering wheel.
4. Install the 2 driver air bag module bolts (1 shown).
-
Tighten to 6 Nm (53 lb-in).
5. Install the 2 driver air bag module bolt caps (1 shown).
6. Turn the ignition from OFF to ON.
7. Install RCM fuse 32 (10A) to the SJB and install the cover.
8. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
9. Prove out the SRS as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back ON and monitor the air bag warning indicator with all SRS
components installed and connected. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air
bag SRS fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.