E 450 V8-5.4L (2009)
Remove the D-ring cover or open the safety belt sling sleeve.
3. Remove the bolt and D-ring or safety belt sling.
-
To install, tighten to 40 Nm (30 lb-ft).
4. For RH retractor, remove the upper rear quarter trim panel, upper front quarter trim panel, lower rear quarter trim panel (if equipped) and lower
front quarter trim panel.
5. For LH retractor, remove the finish panel from the LH lower quarter trim panel.
-
Detach the finish panel from the LH lower quarter trim panel.
-
Disconnect the power point electrical connector.
6. If equipped, remove the bolt and LH safety belt anchor from the floor.
-
To install, tighten to 40 Nm (30 lb-ft).
7. Remove the rear LH safety belt shoulder strap opening cover.
8. Detach the safety belt guide.
9. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
10. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
11. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Safety Belt System.
See: Testing and Inspection/Component Tests and General Diagnostics
Safety Belt Retractor - Third Row, Outboard
Safety Belt Retractor - Third Row, Outboard
RH Safety Belt Retractor
NOTE: Fifteen-passenger vehicle shown, others similar.