E 450 V8-5.4L (2009)
seating position, and it cannot be installed in any other location. Do not remove or alter the locator pin in any way when installing the safety belt retractor
or the safety belt retractor will not function as intended.
1. If equipped, insert an appropriate tool and release the detachable safety belt anchor from the seat.
2. NOTE: Inspect the D-ring cover for damage. If damaged or does not remain attached, install a new D-ring cover.
Remove the D-ring cover or open the safety belt sling sleeve.
3. Remove the bolt and D-ring or safety belt sling.
-
To install, tighten to 40 Nm (30 lb-ft).
4. For RH retractor, remove the upper rear quarter trim panel, upper front quarter trim panel, lower rear quarter trim panel (if equipped) and lower
front quarter trim panel.
5. For LH retractor, remove the quarter trim finish panel, rear upper quarter trim panel (if equipped), rear lower quarter trim panel (if equipped),
front upper quarter trim panel and front lower quarter trim panel.
6. If equipped, remove the bolt and safety belt anchor from the floor.
-
To install, tighten to 40 Nm (30 lb-ft).
7. Detach the safety belt guide.
8. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
9. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
10. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Safety Belt System.
See: Testing and Inspection/Component Tests and General Diagnostics
