E 450 V8-5.4L (2009)
-
Remove and discard the Teflon(R) seal.
-
To install, tighten to 55 Nm (41 lb-ft).
5. Remove the power steering pump bolts and the pump.
-
To install, tighten to 26 Nm (19 lb-ft).
6. NOTE: A new Teflon(R) seal must be installed on the pressure line-to-pump fitting anytime the line is disconnected from the pump.
To install, reverse the removal procedure.
-
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal on the pressure line-to-pump fitting.
7. Fill the power steering system.