E 450 V8-5.4L (2009)
7. Remove the 3 steering gear bolts and the gear.
-
To install, tighten to 165 Nm (122 lb-ft).
8. Secure the steering gear in a vise and remove the sector shaft arm nut and lock washer.
-
To install, tighten to 275 Nm (203 lb-ft).
9. Using the Steering Arm Remover, remove the steering gear sector shaft arm.
10. NOTE: When connecting pressure and return line fittings with O-ring seals, new seals must be installed.
To install, reverse the removal procedure.
-
Install new O-ring seals on the pressure and return line fittings.
-
Install a new cotter pin.
11. Fill the power steering system.