E 450 V8-5.4L (2009)
Assembly
1. Lubricate the sector shaft seal bore with multi-purpose grease.
2. NOTE: Lubricate the sector shaft seal and spacer with multi-purpose grease.
Position the new sector shaft seal and the spacer on the Sector Shaft Seal Installer and install the new sector shaft seal and the spacer.
-
Install the seal and spacer until the spacer is slightly below the snap ring groove.
3. Install the new sector shaft seal snap ring.
4. NOTE: Place the sector shaft dust seal on the Sector Shaft Seal Installer so the raised lip is toward the tool.
Using the Sector Shaft Seal Installer, install the new sector shaft dust seal.
-
Lubricate the steering gear sector shaft dust seal with multi-purpose grease.
5. Position the input shaft bearing in the valve housing.
-
Using a suitable press and the Steering Gear Oil Seal Remover/Installer, seat the bearing.
6. Using the press and the Steering Gear Oil Seal Remover/Installer, install the new input shaft seal.