E 450 V8-5.4L (2009)
Stabilizer Link: Service and Repair
Front Suspension
Stabilizer Bar Link
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the stabilizer link upper nut.
-
To install, tighten the new nut to 80 Nm (59 lb-ft).
3. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the stabilizer link lower nut and remove the stabilizer bar link.
-
To install, tighten the new nut to 80 Nm (59 lb-ft).
4. To install, reverse the removal procedure.