E 450 V8-5.4L (2009)
3. NOTE: This step is required for RH spring only.
If equipped with a 6.8L engine, remove the RH side heat shield bolt and heat shield.
-
To install, tighten the new bolt to 23 Nm (17 lb-ft).
4. NOTE: When tightening the shock absorber upper nut, make sure that the upper shock rod is centered in the frame.
Remove and discard the shock absorber upper nut and bushing.
-
To install, tighten the new nut to 63 Nm (46 lb-ft).
5. Remove and discard the spring upper bracket bolt and remove the spring upper bracket.
-
To install, tighten the new bolt to 23 Nm (17 lb-ft).
6. NOTICE: Use care when lowering the jack, or damage to the front brake hose may occur.
Using the jack, lower the front axle and remove the spring.
7. To install, reverse the removal procedure.
