E 450 V8-5.4L (2009)
Transmissions without a fixed flange
7. Using the Transmission Extension Housing Seal Remover along with the Torque Converter Fluid Seal Remover and Slide Hammer, remove the
extension housing seal.
Installation
Transmissions without a fixed flange
1. Using the Output Shaft Seal Installer, install the extension housing seal.
Transmissions with a fixed flange
2. Using the Transmission Extension Housing Seal Installer, install the output shaft seal.
3. Using the Output Shaft Locknut Socket, install a new output shaft retaining nut.
-
Tighten to 200 Nm (148 lb-ft).
4. Install the output shaft flange and a new bolt.
-
Tighten to 130 Nm (96 lb-ft).