E 450 V8-5.4L (2009)
Transmission Position Switch/Sensor: Service and Repair
TorqShift
Digital Transmission Range (TR) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the selector lever cable end from the manual control lever and position it aside.
3. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter See: Fluid Filter -
A/T/Service and Repair/TorqShift.
4. Disconnect the Transmission Range (TR) sensor connector.
5. NOTE: The pin should be driven up through the manual control lever.
Remove and discard the manual valve detent lever shaft retaining pin.
6. Using the Roll Pin Set, remove the manual valve detent lever shaft retaining pin.