E 450 V8-5.4L (2009)
7. Connect the transmission internal harness to the solenoids.
1. Connect the transmission internal harness connector by pressing it in place by hand and fully seating the connector in place.
2. Connect the EPC solenoid by pressing it in place by hand and fully seating the connector in place.
3. Connect the TCC by pressing it in place by hand and fully seating the connector in place.
4. Connect the shift solenoid SSA and SSB by pressing it in place by hand and fully seating the connector in place.
5. Connect the TFT solenoid by pressing it in place by hand and fully seating the connector in place.
8. NOTE: If the transmission is being repaired for a contamination related failure, use a new transmission fluid filter and seal assembly. The
transmission fluid filter can be reused if no excessive contamination is present.
Install a new transmission fluid filter and seal.
9. NOTICE: The transmission internal wire harness needs to be properly routed to avoid the potential of damage to the harness. Pinched or
trapped internal wire harness may result in a transmission failure.
Make sure that the internal wire harness is properly routed.
10. Position the transmission fluid pan magnet into the transmission fluid pan.
