E 450 V8-5.4L (2009)
2. NOTE: Install the bearing on the coupling shaft with the turned-in lip toward the dust slinger.
NOTE: Install the center bearing bracket with the deep flange facing rearward.
Install the center bearing support on the coupling shaft.
1. Install the rubber insulator in the driveshaft center bearing bracket.
2. Using a suitable press, install the center bearing assembly on the coupling shaft.
3. Install the center bearing retainer.
4. Position the slip-yoke boot clamp on the coupling shaft stub shaft.
5. Slide the small opening end of the slip-yoke boot on the coupling shaft stub shaft, as far as it will travel.
6. Using the Keystone Clamp Installer, crimp the slip-yoke boot clamp.
7. Install the slip-yoke on the coupling shaft.
8. Using the Keystone Clamp Installer, crimp the large slip-yoke boot clamp.
