E 450 V8-5.4L (2009)
3. NOTE: Leave a small portion of the pin exposed.
Install the manual valve detent lever shaft retaining pin into the case.
4. NOTE: When the retaining pin is installed correctly, 2 mm (0.08 in) of the pin will be exposed.
Install a new manual valve detent lever shaft retaining pin.
5. Tighten the TR sensor bolts.
-
Tighten to 10 Nm (89 lb-in).
6. Connect the TR sensor connector.
7. Install the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter See: Automatic
Transmission/Transaxle/Fluid Filter - A/T/Service and Repair/TorqShift.
8. Connect the selector lever cable end to the manual control lever.