E 450 V8-5.4L (2009)
Shift Solenoid: Service and Repair
TorqShift
Shift Solenoids (SS)
Removal and Installation
NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.
NOTE: The Line Pressure Control (LPC) solenoid is not serviced in the vehicle. The solenoid body will need to be removed to remove the LPC
solenoid. For additional information, refer to Solenoid Body Assembly See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/Removal and Replacement/TorqShift.
1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter See: Automatic
Transmission/Transaxle/Fluid Filter - A/T/Service and Repair/TorqShift.
2. Disconnect the affected shift solenoid connector.
3. Remove the affected shift solenoid.
1. Remove the retaining E-clip.
2. Remove the affected shift solenoid.
4. To install, reverse the removal procedure.