E 450 V8-6.0L DSL Turbo (2007)
10. Remove the bolt for the turbocharger oil feed tube.
-
To install, tighten to 10 Nm (89 lb-in).
11. Remove the 2 bolts and the turbocharger oil tube.
-
Discard the turbocharger oil tube gasket.
-
To install, tighten to 23 Nm (17 lb-ft).
12. NOTE: It may be necessary to position the engine wiring harness aside.
Disconnect the engine oil pressure (EOP) switch electrical connector.
13. Remove the EOP switch.
-
To install, tighten to 12 Nm (9 lb-ft).
14. To install, reverse the removal procedure.