E 450 V8-6.0L DSL Turbo (2007)
5. Disconnect the coolant hoses from the air cleaner outlet tube.
6. Loosen the clamps and remove the air cleaner outlet pipe.
7. NOTE: If there is any oil residue, clean both connecting ports and the inside surface of the charge air cooler pipe to prevent the pipe from
blowing off.
Loosen the clamps and remove the charge air cooler (CAC) pipe.
-
To install, tighten to 12 Nm (9 lb-ft).
8. NOTE: Picture taken from inside the vehicle for clarity.
Disconnect the intake air temperature 2 (IAT2) sensor electrical connector.