E 450 V8-6.0L DSL Turbo VIN P (2004)
27. Disconnect the injection control pressure (ICP) sensor electrical connector and wire retainers.
28. Remove the ICP sensor.
^
Plug or cap the opening as needed.
29. Position the wiring away from the valve cover as needed.
30. CAUTION: To prevent engine damage, do not use air powered tools when installing the valve cover.
NOTE: Mark the position of the valve cover bolts for the valve cover bolt installation.
Remove the 11 retainers and the valve cover.
^
Clean and inspect the valve cover gasket.
