E 450 V8-6.0L DSL Turbo VIN P (2004)
3. Using the special tool, remove the crankshaft seal.
4. NOTE: Production engine will not have a wear sleeve.
If equipped, using the special tool, remove the crankshaft damper wear sleeve.
Installation
1. Thoroughly clean the crankshaft front seal mounting surface.
2. Apply Threadlock 262~ to the outer circumference of the leading edge of the crankshaft.
3. NOTE: New seal and wear sleeve must not be separated.
Using the special tool, install the oil seal and wear sleeve assembly.
4. Install the crankshaft damper.