E 450 V8-6.0L DSL Turbo VIN P (2004)
Fuel Injector Control Module: Service and Repair
FUEL INJECTOR CONTROL MODULE
REMOVAL
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Remove the bolts and position the degas bottle aside.
3. CAUTION: Make sure both latches are released before removing the electrical connector or engine damage can occur.
Disconnect the fuel injector control module (FICM) electrical connectors. Position the wiring harness aside.
4. Disconnect the bulkhead connector and position aside.