E 450 V8-6.0L DSL Turbo VIN P (2004)
5. Clean the glow plug bore with a stiff wire brush. Use filtered compressed air to remove foreign material from the glow plug recess.
INSTALLATION
1. Verify that the glow plug bore is completely clean and dry.
2. Apply Threadlock 262(R) sealant to the glow plug sleeve in the two places shown.
3. Install the glow plug sleeve into the glow plug bore until it bottoms.
4. Clean the glow plug sleeve after installation with a nylon brush and solvent. Make sure Threadlock 262(R) sealant is cleaned out before it hardens.
5. Install the lifting bracket on the cylinder head.
6. Install the cylinder heads.