E 450 V8-6.0L DSL Turbo VIN P (2004)
Pressure Regulating Solenoid: Service and Repair
TorqShift Automatic Transmission
Transmission Line Pressure Control Solenoid-PC-A
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the transmission main control valve body.
3. Remove the solenoid body electrical connector O-ring seal.
4. Partially remove the solenoid body electrical wire harness.
1. Remove the wire harness to solenoid body bolts.
2. Disconnect the electrical connector from the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C)
3. Lift the tab on the bulkhead connector, twist and push the bulkhead connector through the solenoid body.
5. Remove the pressure control solenoid (PC-A).
1. Remove the (E) retaining clips from the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C).
2. Partially slide the shift solenoid (SSPC-C) back enough to gain clearance to remove the pressure control solenoid (PC-A).
3. Remove the pressure control solenoid (PC-A).
Installation