E 450 V8-6.0L DSL Turbo VIN P (2004)
7. Install the RH crossmember bracket nuts.
8. Install the wire harness and install the two retaining clips to the rear of the crossmember.
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the output shaft speed (OSS) sensor.
3. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of debris to prevent contamination of the
transmission.
Remove the output shaft speed (OSS) sensor.
1. Remove the bolt.
2. Remove the output shaft speed (OSS) sensor.
Installation