E 450 V8-6.0L DSL Turbo VIN P (2004)
4. NOTE: Depending on the paint markings, there are two methods of indexing the driveshaft and the output shaft.
Install the driveshaft.
1
Preferred method - align the factory-made paint marks on the output shaft and driveshaft and position the driveshaft in the transmission.
^
Alternate method - align the index-marks and position the driveshaft in the transmission.
5. CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply sealer to the threads of the original bolts. The driveshaft
flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts evenly in a cross pattern
as shown.
Position the driveshaft flange yoke on the pinion flange with the index marks aligned, and install the bolts.