E 450 V8-6.0L DSL Turbo VIN P (2004)
Transmission Speed Sensor: Service and Repair
4R100 Automatic Transmission
Turbine Shaft Speed (TSS) Sensor and Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL position it on a hoist.
2. Remove the rear transmission mount nuts.
3. Position the high-lift transmission jack under the transmission.
4. CAUTION: Be sure not to raise the back of the transmission too high, if it makes contact with the underbody, damage to the turbine shaft speed
(TSS) and output shaft speed (OSS) sensors will occur.
Remove the rear transmission mount.
1. Raise the transmission up off the rear crossmember support.
2. Remove the bolts.
3. Remove the rear transmission mount.
5. Lower the transmission to gain access to the TSS sensor and the OSS sensor.