Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
Voltage Regulator: Service and Repair
REMOVAL
1. Remove the Generator (GEN).
2. Remove the generator brush and terminal holder and the Voltage Regulator (VR).
1
Remove the screws.
2
Remove the generator brush and terminal holder and the voltage regulator.
3. Separate the generator brush and terminal holder from the voltage regulator.
1
Remove the screw cap.
2
Remove the screws.
3
Separate the generator brush and terminal holder from the voltage regulator.
INSTALLATION
1. Install the brush and terminal holder on the voltage regulator.
1
Position the brush and terminal holder on the voltage regulator.
2
Install the screws.
3
Install the screw cap.
CAUTION: Make sure screw cap is installed over Test Terminal A to prevent accidental shorting of the battery positive (B+) connection.