Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
Using a suitable tool as shown, disconnect the driveshaft flange yoke from the pinion flange.
6. Lower the driveshaft and slide it off the output shaft.
Installation
1. Inspect the extension housing seal for damage. Install a new seal as necessary.
2. Check to see if a paint mark is present on the front of the driveshaft and on the end of the transmission output shaft.
^
E150 and E250 vehicles equipped with 4R70W transmissions have the paint mark.
^
E350 and E450 vehicles equipped with 4R100 transmissions do not have the paint mark.
3. Lubricate the slip-yoke spline with Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.
