Econoline E150 1/2 Ton V8-5.4L CNG VIN M (1998)
Steering Angle Sensor: Service and Repair
REMOVAL
CAUTION: The steering column must be in the locked position, or the lower end of the column wired in such a way that the steering column does
not rotate, resulting in damage to the air bag sliding contact.
NOTE: Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; replace with new bolts.
1. Remove the bolt retaining the upper shaft assembly U-joint to the steering column center shaft.
2. Remove the shock absorber electronic steering sensor.
(1) Disconnect the electrical connector.
(2) Remove the screws.
(3) Remove the shock absorber electronic steering sensor.
3. Remove the sensor ring.
(1) Remove the steering column lower bearing spring.
(2) Remove the sensor ring.
INSTALLATION
1. Follow the removal procedure in reverse order.
