Econoline E250 3/4 Ton V8-4.6L SOHC VIN W (2000)
Seals and Gaskets: Service and Repair
Special Tools
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Note: To maintain initial driveshaft balance, mark the driveshaft yoke and axle flange so they will be installed in their original positions.
Remove the driveshaft.
4. Disconnect the catalyst monitoring sensor harness connectors. Remove the harness bracket.
5. Remove the transmission insulator and retainer.
6. Use the (A) Seal Remover and the (B) Impact Slide Hammer to remove the (C) extension housing seal.
7. Remove the extension housing and gasket.