Econoline E250 3/4 Ton V8-5.4L CNG VIN M (1998)
Keyless Entry Transmitter: Service and Repair
Programming - Keyless Entry Remote Transmitter
NOTE: To program (or reprogram) a keyless entry remote transmitter into the Remote Keyless Entry (RKE) module, perform the following steps:
1. Turn the key to the RUN or ACC position and short the two terminals of the program connector, a two-pin connector located at the base of the
steering column connected to the ignition switch wiring harness. All doors should lock and then unlock.
2. Press any button on each keyless entry remote transmitter in turn. All doors should lock and then unlock. If the door locks do not respond, press
the button again (up to three times maximum with the same keyless entry remote transmitter).
3. Repeat Step 2 to program additional keyless entry remote transmitters into the RKE module (up to four keyless entry remote transmitters
maximum).
4. Turn the key off.
5. Remove the short from the program connector. All doors should lock and then unlock.
6. Verify that the keyless entry remote transmitters have been successfully programmed by pressing the lock or unlock button on each one, and
observing that the system responds by locking and unlocking the doors.