Econoline E250 3/4 Ton V8-5.4L SOHC VIN L (1998)
NOTE: The black side of the bearing must face upward.
One-Way Clutch, A/T
DISASSEMBLY
1. Remove the (A) output shaft ring gear and the (B) No. 12 thrust bearing.
2. If necessary, remove the low one-way clutch assembly by rotating it counterclockwise to unlock the tabs.
3. Inspect the following:
-
Reverse clutch hub thrust surfaces for scores.
-
Reverse clutch hub splines for wear.
-
Outer and inner low/reverse one-way clutch race for scores and damaged surface areas where rollers contact races.
-
Rollers and springs for excessive wear or damage.
-
Spring and cage.
ASSEMBLY
1. Follow the removal procedure in reverse order.