Econoline E250 3/4 Ton V8-5.4L SOHC VIN L (1998)
Driveshafts built 12/24/1998 and forward have the "Circular" rear flange (Figure 4) and the "Involute Spline" slip yoke (Figure 6).
NOTE
THE DAMPENED DRIVESHAFT KITS CONTAIN THE REAR DRIVESHAFT, THE SLIP YOKE BOOT, MOUNTING HARDWARE FOR
THE SLIP YOKE BOOT AND A 13 mm SPACER. THE 13 mm SPACER MAY BE USED TO LOWER THE CENTER BEARING TO
IMPROVE DRIVESHAFT ANGLES IF NEEDED. THE FRAME CROSSMEMBER THAT THE CENTER BEARING ATTACHES TO WAS
LOWERED BY 13 mm ON FEBRUARY 21, 1999. DO NOT USE THE 13 mm SPACER ON UNITS BUILT AFTER FEBRUARY 21, 1999.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 509000, 597997, 702000, 702200, 702300
Service Procedure
NOTE
DANA MODEL 80 AXLES WERE REPLACED IN PRODUCTION BY DANA MODEL 70 T-RIB
AXLES ON:
ENGINE/RATIO
CHANGE-OVER DATE
7.3L/4.10
December 18, 1999
5.4L/6.8L/4.63
May 22 and 23, 2000 (4.63, Mixed
built on the 22nd and 23rd)
Hints for determining the type of axle: Dana 80 axles were only used on E-Series units where the 5th position of the VIN is "E" and the 6th position of
the VIN is "4" (E40, E45, E47, E49). The parking brake position also provides a way to ensure, that you are working on an E-450. All E-450s have the
parking brake at the back of the transmission on the driveshaft. If there is not a parking brake assembly on the driveshaft, the vehicle being worked on is
not an E-450 and this TSB does not apply.