Econoline E250 3/4 Ton V8-5.4L SOHC VIN L (1998)
Slip Yoke: Service and Repair
Special Tools
DISASSEMBLY
1. Remove the driveshaft slip yoke boot.
1. With the front driveshaft on a bench, cut and discard the driveshaft slip yoke boot clamps.
2. Separate the driveshaft slip yoke from the splined stub shaft on the driveshaft.
CAUTION: Do not clamp the driveshaft in the jaws of a vise or similar holding fixture.
2. Remove the driveshaft slip yoke boot.
-
Inspect the driveshaft slip yoke boot for damage and replace if required.
3. Inspect the lubricant for contamination. If contaminated, disassemble the driveshaft and inspect the stub shaft and driveshaft slip yoke for wear.
Replace as needed.
ASSEMBLY