Econoline E350 1 Ton V10-6.8L VIN S (1998)
Brake Rotor/Disc: Service and Repair
Brake Rotor/Disc
REMOVAL
1. Remove the front disc brake caliper anchor plate.
2. Remove the front disc brake hub and rotor as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the front disc brake hub and rotor.
3. If necessary, resurface the front disc brake hub and rotor. Ford recommends on-vehicle rotor machining. Follow the lathe manufacturer's
instructions.
1
Remove the wheel hub grease seal.
2
Remove the inner front wheel bearing.
INSTALLATION
1. Thoroughly clean and inspect the front wheel bearings and the front disc brake hub and rotor.
-
Use Metal Brake Parts Cleaner F3AZ-19579-SA or equivalent.
2. Lubricate the front wheel bearings.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.