Econoline E350 1 Ton V10-6.8L VIN S (1998)
Oil Pan: Service and Repair
Installation
1. Install the oil pump screen cover and tube.
2. Apply a bead of silicone where the front cover an the rear crankshaft seal retainer fit to the engine block.
-
Use Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A6.
NOTE: If not secured within 4 minutes, sealant must be removed and the sealing area cleaned wit Metal Surface Cleaner F4AZ-19A536-RA or
equivalent meeting Ford specification WSE-MSB392-A. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer Failure
to follow this procedure can cause future oil leakage.
3. Tighten the bolts in the sequence shown.
-
Stage 1: Tighten to 2 Nm (18 inch lbs.)
-
Stage 2: Tighten to 20 Nm (15 ft. lbs.)
-
Stage 3: Tighten an additional 60 degrees
NOTE: Be sure to tighten the bolts in three stages.