ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Suspension - Rear End Sagging Condition|Page 5345 > < Suspension - Rear End Sagging Condition|Page 5339
Page 1
background image

Suspension Spring ( Coil / Leaf ): All Technical Service Bulletins
Suspension - Rear End Sagging Condition

TSB 07-14-3

07/23/07

CUTAWAY AND STRIP CHASSIS VEHICLES - REAR 
AXLE/SPRING SPACER

FORD:
1999-2003 E-350

ISSUE
Some 1999-2003 E-350 vehicles may have a rear spring sag condition where the customer may complain about the appearance of reduced clearance to
the caliper bolt.

ACTION
Install a 5/32" (9.65 mm) spacer between the rear leaf springs and axle by following the Service Procedure.

SERVICE PROCEDURE

1.

Remove the rear leaf springs per Work Shop Manual (WSM), Section 204-02.

2.

Place the springs on a table and remove the leaf spring center bolt.

3.

Replace the leaf spring center bolt and install the axle/spring spacer by:

a.

Place the spacer at the spring bottom (Figure 1).

b.

Install the new center bolt through the spacer and leaf spring (with the bolt head in contact with the spacer).

c.

Clamp and compress the leaf spring leafs and spacer together.

Suspension - Rear End Sagging Condition|Page 5345 > < Suspension - Rear End Sagging Condition|Page 5339