Econoline E350 1 Ton V8-5.4L CNG VIN M (1999)
2. Assemble the retainer clips to the ears of the clutch plates. Make sure both clips are completely assembled or seated onto the ears of the clutch
plates.
3. NOTE: To prevent the rear axle disc and plate kit from falling out of the differential case, hold in place by hand while repositioning the
differential case on a bench.
Assemble the rear axle disc and plate kit and differential side gear into the differential case. Make sure the rear axle disc and plate kit stays
assembled to the splines of the differential side gear, and the retainer clip is completely seated into the pocket of the differential case.
4. Reposition the differential case on the bench. Install the special tool into the bottom side gear bore.
^
Apply a small amount of Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-B into the centering hole
of the step plate.
5. NOTE: Make sure the differential clutch pack stays assembled to the splines of the differential side gear, and the retainer clips are completely
seated into the pockets of the differential case.