Econoline E350 1 Ton V8-5.4L CNG VIN M (1999)
Using a suitable pinion flange holding tool to hold the rear axle universal joint flange, remove the drive pinion shaft nut.
6. Using the 2-Jaw Puller, remove the rear axle universal joint flange.
7. Using the Seal Remover in combination with the Impact Slide Hammer, remove the pinion seal.
8. Clean the rear axle pinion seal seat.
Installation
1. CAUTION: Installation without the correct tool can result in early seal failure. If the pinion seal becomes cocked during installation, remove and
install a new one. Use care to make sure the garter spring remains in place during assembly. If the spring is dislodged, the pinion seal must be
installed new.
NOTE: Drive the pinion seal into the housing, using the Pinion Seal Replacer for Model 60 or 70 axle or the Pinion Oil Seal Replacer for Model
80 axle.
NOTE: The rear axle universal joint flange must never be hammered on or installed with power tools.
NOTE: For Model 80, install the rear axle universal joint flange using the Companion Flange Replacer.