Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
-DDX or MERCON equivalent after mounting to the transmission extension housing.
2. Check and, if necessary, fill the parking brake assembly with Motorcraft MERCON Multi-Purpose Automatic Transmission Fluid XT-2-QDX or
-DDX or MERCON equivalent to the bottom of the filler plug hole.
-
If necessary, replace and tighten the filler plug.
3. Install the driveshaft.
4. Position the (A) front parking brake cable and conduit and press the (B) retainer into the (C) cable bracket until it snaps into place.
5. Set adjusting clevis.
-
Loosen the jam nut several turns.
-
Position the parking brake lever in the applied position.
-
Tighten or loosen the adjusting clevis until the adjusting clevis hole lines up with the parking brake lever hole, and then loosen the adjusting
clevis 13 mm (0.5 inch).
6. Install the pins and tighten the jam nut.
-
Install the (A) clevis pin through the (B) adjusting clevis and the (C) parking brake lever.
-
Install the locking pin in the clevis pin.
-
Tighten the jam nut.
